LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (3.6L Engine (Service Information)) >> Air Intake System >> Body, Air Cleaner >> Installation

Body, Air Cleaner: Installation

WARNING: This page is about a different variant/trim than selected.
GC0192200Courtesy of CHRYSLER GROUP, LLC
  1. Install the air cleaner body (1) straight down on the locating pins (2).
    GC0192197Courtesy of CHRYSLER GROUP, LLC
  2. Install the fresh air makeup hose (1) to the air cleaner body.
    GC0192174Courtesy of CHRYSLER GROUP, LLC
  3. Install the hood seal (1).
    GC0173627Courtesy of CHRYSLER GROUP, LLC
  4. Install the resonator to the air cleaner body and the throttle body engaging the rubber grommets (3).
  5. Tighten the clamp at the throttle body (1) and the air cleaner body (2) to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
    GC0192172Courtesy of CHRYSLER GROUP, LLC
  6. Secure the wire harness retainer (2) to the air cleaner resonator.
  7. Connect the wire harness connector (1) to the Inlet Air Temperature (IAT) sensor.
  8. Install the engine cover. Refer to COVER, ENGINE, INSTALLATION .
  9. Connect the negative battery cable.
scientia non olet · About LEMON Manuals