LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2019 >> Durango SXT Plus, AWD >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Bumpers >> Bumpers >> Fascia, Rear >> Removal

Fascia, Rear: Removal

GC0146424Courtesy of CHRYSLER GROUP, LLC
  1. Remove the wheel opening flare molding (1). Refer to MOLDING, REAR WHEEL OPENING, REMOVAL .
    GC0146415Courtesy of CHRYSLER GROUP, LLC
  2. Open the rear liftgate (1).
  3. Remove the two lower retainers (4) at the rear support beam.
  4. Remove the fasteners (5) at the back sides of the quarter panels, in the liftgate opening.
  5. Remove the fasteners (3) on both sides at the wheel well openings.
    GC0146425Courtesy of CHRYSLER GROUP, LLC
  6. Release the integral latch features at the sides (5) and along the back (4) and separate the fascia (1) from the vehicle.
  7. Disconnect the body harness electrical connector (3) and remove the fascia.
  8. Remove both the park assist (6) and blind spot sensors (2), if equipped.
  9. Remove the sensor electrical harness.
scientia non olet · About LEMON Manuals