Shifter - Floor Mount
WARNING: This page is about a different variant/trim than selected.
| 1 - GEARSHIFT CABLE |
| 2 - CABLE RETAINER AND NOTCH |
| 3 - SHIFTER ASSEMBLY PIN |
| 4 - SHIFT LEVER |
| 5 - ADJUSTMENT BOLT |
- Remove any necessary console parts for access to shift lever assembly and shifter cables. Refer to CONSOLE, FLOOR, REMOVAL .
- Shift transmission into PARK.
- Disconnect the transmission shift cable (1) at shift lever (3) and shifter assembly bracket (2).
- Remove the shift cable retainer (2) from the notch in the shifter assembly (2).
1 - SHIFTER ASSEMBLY 2 - WIRING CONNECTORS - Disengage all wiring connectors (2) from the shifter assembly (1).
1 - SHIFTER ASSEMBLY 2 - NUTS 3 - GEARSHIFT CABLE - Remove all nuts (2) holding the shifter assembly (1) to the floor pan.
- Remove the shifter assembly (1) from the vehicle.