LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Charger SXT Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Nag1 Automatic Transmission (Service Information)) >> Cable, Shift >> Removal >> Floor Mount

Floor Mount

WARNING: This page is about a different variant/trim than selected.
  1. Shift transmission into PARK.
  2. Raise vehicle.
    GC0095837Courtesy of CHRYSLER GROUP, LLC
  3. Remove the gearshift cable retaining clip (4) (if equipped).
  4. Disengage the gearshift cable (1) eyelet at transmission manual shift lever (3) and pull cable out of the mounting bracket (2).
  5. Lower the vehicle.
  6. Remove the floor console as necessary to access the shift mechanism and cables. Refer to CONSOLE, FLOOR, REMOVAL .
  7. If necessary, remove the bolts holding the shield, covering the gearshift and park lock cables, to the floorpan and remove the shield.
    GC0081250Courtesy of CHRYSLER GROUP, LLC
    1 - GEARSHIFT CABLE
    2 - CABLE RETAINER AND NOTCH
    3 - SHIFTER ASSEMBLY PIN
    4 - SHIFT LEVER
    5 - ADJUSTMENT BOLT
  8. Remove the gearshift cable (1) from the shift lever pin (3).
  9. Remove the gearshift cable retainer (2) from the notch (2) in the shifter assembly.
    GC0081251Courtesy of CHRYSLER GROUP, LLC
    1 - GEARSHIFT CABLE
    2 - GROMMET
  10. From under the hood, remove the shift cable grommet (2) from the dash panel.
  11. Remove gearshift cable (1) from vehicle.
scientia non olet · About LEMON Manuals