LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Instrument Panel) >> Base Trim >> Removal

Base Trim: Removal

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the instrument panel from the vehicle. (Refer to BODY/INSTRUMENT PANEL-REMOVAL  ).
  3. Place the instrument panel on a suitable work surface. Be certain to take the proper precautions to protect the instrument panel from any possible cosmetic damage.
  4. Remove the instrument cluster from the instrument panel. (Refer to REMOVAL ).
  5. Remove the radio from the instrument panel. (Refer to REMOVAL ).
  6. Remove the top cover from the instrument panel. (Refer to BODY/INSTRUMENT PANEL/TOP COVER-REMOVAL  ).
    NOTE: Four of the screws secure the lower instrument panel duct to the base trim.
  7. Remove the screws around the perimeter of the instrument panel that secure the base trim to the instrument panel structural support.
  8. Remove the base trim from the instrument panel structural support.
scientia non olet · About LEMON Manuals