Section 64 (Doors - Rear): Latch: Installation
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the latch harness connector.
- Install screws attaching latch to rear door and tighten to 10 N.m (85 in. lbs.).
- Connect latch rods to latch.
- Reposition the waterdam.
- Install trim panel. (Refer to BODY/DOORS-REAR/TRIM PANEL-INSTALLATION )
- Adjust the latch if necessary. (Refer to BODY/DOORS-REAR/LATCH-ADJUSTMENTS )