Section 64 (Doors - Rear): Latch: Adjustments
WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Locate the access hole and insert a 5/32 in hex-wrench through the hole and into the adjustment screw (Fig 1 ).
- Loosen the screw and operate the outside handle several times to release any restriction because of misalignment.
- Tighten the adjustment screw to 3 N.m (30 in. lbs.).
- Test handle for proper operation.