LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Door - Front) >> Latch >> Installation

Section 63 (Door - Front): Latch: Installation

WARNING: This page is about a different car, the 2004 Dodge Dakota and 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect latch rod to outside handle.
  2. Connect inside handle to latch rod to the latch.
  3. Connect lock cylinder to latch rod to the latch.
  4. Connect lock button to latch rod to the latch.
  5. Position latch in door.
  6. Install screws attaching latch to door shut face and tighten to 10 N.m (85 in. lbs.).
  7. Connect outside handle to latch rod to the latch.
  8. Connect wire harness connector for power door locks, if equipped.
  9. Install rearward glass run channel.
  10. Reposition water dam.
  11. Install door trim panel. (Refer to BODY/DOOR-FRONT/TRIM PANEL-INSTALLATION  )
  12. Adjust outside handle if necessary. (Refer to BODY/DOOR-FRONT/LATCH-ADJUSTMENTS  )
    Fig 1: Removing Screws Attaching Latch To Door Shut Face
    G02655678Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals