LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Engine - 5.9L) >> Rocker Arm / Adjuster Assembly >> Installation

Rocker Arm / Adjuster Assembly: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate the crankshaft until the "V8" mark lines up with the TDC mark on the timing chain case cover. This mark is located 147° ATDC from the No.1 firing position.
  2. Install the push rods in the same order as removed.
  3. Install rocker arm and pivot assemblies in the same order as removed. Tighten the rocker arm bolts to 28 N.m (21 ft. lbs.) torque.
    CAUTION: DO NOT rotate or crank the engine during or immediately after rocker arm installation. Allow the hydraulic roller tappets adequate time to bleed down (about 5 minutes).
  4. Install cylinder head cover (Refer to ENGINE/CYLINDER HEAD/CYLINDER HEAD COVER(S)-INSTALLATION ).
scientia non olet · About LEMON Manuals