LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Air Bag Restraint Systems) >> Vehicle Communications >> Test 1C: DRBIII Blank Screen

Test 1C: DRBIII Blank Screen

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Prior to performing any air bag system test, go to PRETEST INSPECTION & DIAGNOSTIC PROCEDURE  under DIAGNOSTICS. Perform air bag verification test after all repairs unless otherwise directed. See TEST VER-1: AIR BAG VERIFICATION TEST  under DIAGNOSTIC TESTS.
  1. Disconnect DRBIII from Data Link Connector (DLC). Measure voltage between ground and DLC connector terminal No. 16 (fused B+ circuit, Pink wire). See Fig 1. If voltage is more than 11 volts, go to next step. If voltage is less than 11 volts, repair open in Pink wire. See WIRING DIAGRAMS .
  2. Measure resistance between ground and DLC connector terminals No. 4 (ground circuit, Black/Light Green wire) and No. 5 (ground circuit, Orange/Black wire). If resistance is less than 5 ohms in both circuits, go to next step. If resistance is more than 5 ohms, repair open in appropriate wire.
  3. Substitute an known good DRBIII cable. If DRBIII is operational, replace original DRBIII cable. If DRBIII is not operational, go to next step.
  4. Substitute an known good DRBIII tester. If DRBIII is operational, repair original DRBIII tester. If DRBIII is not operational, test is complete. Diagnose vehicle communication system.
Fig 1: Identifying Data Link Connector (DLC) Terminals
G99G22372Courtesy of DAIMLERCHRYSLER CORP.
scientia non olet · About LEMON Manuals