Removal & Installation (4.7L)

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

Partially drain cooling system to below Engine Coolant Temperature (ECT) sensor level. ECT sensor is located on front of intake manifold. See Fig 1. Disconnect ECT sensor electrical connector and remove ECT sensor from intake manifold.
To install, reverse removal procedure. Tighten ECT sensor to specification. See TORQUE SPECIFICATIONS . Fill cooling system.

Fig 1: Locating Engine Coolant Temperature & Manifold Absolute Pressure Sensors (4.7L)

Courtesy of DAIMLERCHRYSLER CORPORATION