LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Ignition Coil >> Installation (4.7L)

Installation (4.7L)

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using compressed air, blow out any dirt or contaminants from around top of spark plug.
  2. Check condition of coil "O" ring and replace as necessary. To aid in coil installation, apply silicone to coil "O" ring.
  3. Position ignition coil into cylinder head opening and push onto spark plug. Do this while guiding coil base over mounting stud.
  4. Install and tighten coil mounting stud nut to specification. See TORQUE SPECIFICATIONS .
  5. Connect electrical connector to coil by snapping into position. If necessary, install throttle body air tube or box.
scientia non olet · About LEMON Manuals