LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Controls - Removal, Overhaul & Installation) >> Emission Systems & Sub-Systems >> EVAP Canister >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise vehicle. Disconnect vacuum lines at EVAP canister. Note location of lines before removal. Remove canister mounting nut and canister from mounting bracket.
  2. For installation, position canister locating pins into mounting bracket grommets and install mounting nut. Tighten mounting nut to specification. See TORQUE SPECIFICATIONS . Connect vacuum lines at canister. Lower vehicle.
scientia non olet · About LEMON Manuals