LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Diagnostic Procedures) >> Diagnostic Information And Procedure >> Interior Lighting >> Symptom: *Glove Box Lamp Inoperative >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
GLOVE BOX LAMP INOPERATIVE - DIAGNOSTIC PROCEDURE

TEST ACTION
1 Remove and inspect the inoperative bulb.
Is the inspected bulb OK?
  1. Yes --> Go To 2
  2. No --> Replace the inoperative bulb.

    Perform BODY VERIFICATION TEST - VER 1  .
2 Disconnect the Glove Box Lamp Switch harness connector.
Disconnect the Central Timer Module harness connector
Measure the resistance of the Glove Box Lamp Driver Circuit between the Central Timer Module harness connector and the Glove Box Lamp Switch harness connector.
Is the resistance below 5.0 ohms?
  1. Yes --> Go To 3
  2. No --> Repair the Glove Box Lamp Driver Circuit for a short to ground.

    Perform BODY VERIFICATION TEST - VER 1  .
3 Disconnect the Glove Box Lamp Switch harness connector.
Disconnect the Central Timer Module harness connector.
Measure the resistance between the Glove Box Lamp Switch harness connector and the Central Timer Module harness connector.
Is the resistance below 5.0 ohms?
  1. Yes --> Replace the Central Timer Module.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Replace the Glove Box Lamp Switch

    Perform BODY VERIFICATION TEST - VER 1  .
scientia non olet · About LEMON Manuals