Body Verification Test - VER 1

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

BODY VERIFICATION TEST - VER 1 CHART

BODY VERIFICATION TEST - VER 1
Disconnect all jumper wires and reconnect all previously disconnected components and connectors. NOTE: If the SKIM or PCM was replaced, refer to service information for proper programming procedures. If the Central Timer Module was replaced, turn the ignition on for 15 seconds (to learn VIN) or engine may not start (if VTSS equipped). If the vehicle is equipped with VTSS, use the DRBIII(R) and enable VTSS and EQ setting. Program all RKE transmitters and other options as necessary. If any HVAC door actuators were replaced/door linkage was repaired, with the DRBIII(R) in HVAC, System Tests, select HVAC Door Recalibration. If any HVAC door actuator circuits were repaired, with the DRBIII(R) in HVAC, System Tests, select Actuator Circuit Test. Ensure all accessories are turned off and the battery is fully charged. With the DRBIII(R), record and erase all DTCs from ALL modules. Start and run the engine for 2 minutes. Operate all functions of the system that caused the original concern. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII(R), read DTC's from ALL modules. Are any DTC's present or is the original condition still present? Yes --> Repair is not complete, refer to appropriate symptom. No --> Repair is complete.

BODY VERIFICATION TEST - VER 1

Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
NOTE: If the SKIM or PCM was replaced, refer to service information for proper programming procedures.
If the Central Timer Module was replaced, turn the ignition on for 15 seconds (to learn VIN) or engine may not start (if VTSS equipped). If the vehicle is equipped with VTSS, use the DRBIII(R) and enable VTSS and EQ setting.
Program all RKE transmitters and other options as necessary.
If any HVAC door actuators were replaced/door linkage was repaired, with the DRBIII(R) in HVAC, System Tests, select HVAC Door Recalibration.
If any HVAC door actuator circuits were repaired, with the DRBIII(R) in HVAC, System Tests, select Actuator Circuit Test.
Ensure all accessories are turned off and the battery is fully charged.
With the DRBIII(R), record and erase all DTCs from ALL modules. Start and run the engine for 2 minutes. Operate all functions of the system that caused the original concern.
Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII(R), read DTC's from ALL modules.

Are any DTC's present or is the original condition still present?

Yes --> Repair is not complete, refer to appropriate symptom.
No --> Repair is complete.