LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Diagnostic Procedures) >> Diagnostic Information And Procedure >> Instrument Cluster >> Symptom: *Seat Belt Indicator Always Off >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
SEAT BELT INDICATOR ALWAYS OFF - DIAGNOSTIC PROCEDURE

TEST ACTION
1
NOTE: Diagnose and repair any Airbag Control Module (ACM) DTCs before proceeding with this test.
Turn the ignition off.Disconnect the Seat Belt Switch harness connector.Check connectors - Clean/repair as necessary.Turn the ignition on.Observe the Seat Belt Indicator after the Instrument Cluster completes the bulb check.Does the indicator illuminate?
  1. Yes --> Replace the Seat Belt Switch.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Go To 2
2 Turn the ignition off.
Disconnect the Seat Belt Switch harness connector.
Disconnect the Instrument Cluster C2 harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance of the Seat Belt Indicator Driver circuit to ground.
Does the resistance measure less than 5.0 ohms?
  1. Yes --> Repair the short to ground in the Seat Belt Indicator Driver circuit.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Replace the Instrument Cluster in accordance with the Service Information.

    Perform BODY VERIFICATION TEST - VER 1  .
scientia non olet · About LEMON Manuals