LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Diagnostic Procedures) >> Diagnostic Information And Procedure >> Instrument Cluster >> Symptom: *Low Washer Fluid Indicator Always On >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
LOW WASHER FLUID INDICATOR ALWAYS ON - DIAGNOSTIC PROCEDURE

TEST ACTION
1 Ensure that the Washer Fluid reservoir is properly filled.
Disconnect the Washer Fluid Level Switch harness connector.
Turn the ignition on.
NOTE: When operating properly, the Instrument Cluster will delay illuminating the indicator for approximately 30 seconds.

Observe the Low Washer Fluid Indicator.
Does the indicator illuminate?
  1. Yes --> Go To 2
  2. No --> Replace the Washer Fluid Level Switch.

    Perform BODY VERIFICATION TEST - VER 1  .
2 Turn the ignition off.
Disconnect the Washer Fluid Level Switch harness connector.
Disconnect the Instrument Cluster C2 harness connector.
Check connectors - Clean/repair as necessary.
Measure the resistance of the Washer Fluid Switch Sense circuit to ground.
Does the resistance measure below 5.0 ohms?
  1. Yes --> Repair the short to ground in the Washer Fluid Switch Sense circuit.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Replace the Instrument Cluster in accordance with the Service Information.

    Perform BODY VERIFICATION TEST - VER 1  .
scientia non olet · About LEMON Manuals