LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2003 >> Durango Base, 5.9 Z, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Diagnostic Procedures) >> Diagnostic Information And Procedure >> Audio >> Symptom: Right Front Input No Activity >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
RIGHT FRONT INPUT NO ACTIVITY - DIAGNOSTIC PROCEDURE

TEST ACTION
1
NOTE: The fault condition must be present to continue diagnosis. Use the DRBIII(R) to perform the Amplifier pretest to verify the fault condition is present before continuing diagnosis.
Turn the ignition off.Disconnect the Amplifier C2 harness connector.Disconnect the Radio harness connector.Measure the resistance between ground and the right front speaker (+) circuit.Is the resistance below 1000.0 (1K) ohms?
  1. Yes --> Repair the speaker (+) circuit for a short to ground.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Go To 2
2 Turn the ignition off.
Disconnect the Amplifier C2 harness connector.
Disconnect the Radio harness connector.
Measure the resistance between ground and the right front speaker (-) circuit.
Is the resistance below 1000.0 (1K) ohms?
  1. Yes --> Repair the speaker (-) circuit for a short to ground.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Go To 3
3 Turn the ignition off.
Disconnect the Amplifier C2 harness connector.
Disconnect the Radio harness connector.
Measure the resistance of each right front speaker (+) and (-) circuit between the Radio and the Amplifier.
Is the resistance below 5.0 ohms for each circuit?
  1. Yes --> Go To 4
  2. No --> Repair the speaker circuits for an open.

    Perform BODY VERIFICATION TEST - VER 1  .
4 Turn the ignition off.
Reconnect the Radio harness connector.
Disconnect the Amplifier C2 harness connector.
Turn the ignition on and the Radio on to a known good radio station or have a tape or CD playing.
Turn the radio volume control up at least 25 positions.
With the voltmeter in the AC voltage scale, measure the voltage of each right front speaker circuit at the Amplifier C2 connector.
NOTE: Perform this test on each right front speaker circuit.

Is the voltage at least 120 mV AC (0.12 VAC) on each speaker circuit?
  1. Yes --> Replace the Amplifier in accordance with the Service Information.

    Perform BODY VERIFICATION TEST - VER 1  .

  2. No --> Replace the Radio.

    Perform BODY VERIFICATION TEST - VER 1  .
scientia non olet · About LEMON Manuals