Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.

PCI FAILURE - DIAGNOSTIC PROCEDURE

TEST	ACTION
1	NOTE: The fault condition must be present to continue diagnosis. Use the DRBIII(R) to perform the Amplifier pretest to verify the fault condition is present before continuing diagnosis. Turn the ignition on.With the DRBIII(R), perform the Amplifier pretest.Is the fault condition present? Yes --> Replace the Amplifier in accordance with the Service Information. Perform BODY VERIFICATION TEST - VER 1 . No --> Refer SYSTEM WIRING DIAGRAMS to help isolate a possible intermittent condition. Perform BODY VERIFICATION TEST - VER 1 .

TEST

ACTION

NOTE: The fault condition must be present to continue diagnosis. Use the DRBIII(R) to perform the Amplifier pretest to verify the fault condition is present before continuing diagnosis.

Turn the ignition on.With the DRBIII(R), perform the Amplifier pretest.Is the fault condition present?

Yes --> Replace the Amplifier in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1 .
No --> Refer SYSTEM WIRING DIAGRAMS to help isolate a possible intermittent condition.
Perform BODY VERIFICATION TEST - VER 1 .