Diagnostic Procedure
WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
LEFT REAR INPUT NO ACTIVITY - DIAGNOSTIC PROCEDURE
| TEST | ACTION |
|---|---|
| 1 |
NOTE:
The fault condition must be present to continue diagnosis. Use the DRBIII(R) to perform the Amplifier pretest to verify the fault condition is present before continuing diagnosis. Turn the ignition off.Disconnect the Amplifier C2 harness connector.Disconnect the Radio harness connector.Measure the resistance between ground and the left rear speaker (+) circuit.Is the resistance below 1000.0 (1K) ohms?
|
| 2 | Turn the ignition off. Disconnect the Amplifier C2 harness connector. Disconnect the Radio harness connector. Measure the resistance between ground and the left rear speaker (-) circuit. Is the resistance below 1000.0 (1K) ohms?
|
| 3 | Turn the ignition off. Disconnect the Amplifier C2 harness connector. Disconnect the Radio harness connector. Measure the resistance of each left rear speaker (+) and (-) circuit between the Radio and the Amplifier. Is the resistance below 5.0 ohms for each circuit?
|
| 4 | Turn the ignition off. Reconnect the Radio harness connector. Disconnect the Amplifier C2 harness connector. Turn the ignition on and the Radio on to a known good radio station or have a tape or CD playing. Turn the radio volume control up at least 25 positions. With the voltmeter in the AC voltage scale, measure the voltage of each left rear speaker circuit at the Amplifier C2 connector.
NOTE:
Perform this test on each left rear speaker circuit. Is the voltage at least 120 mV AC (0.12 VAC) on each speaker circuit?
|