Diagnostic Procedure
WARNING: This page is about a different car, the 2004 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
ALL CHANNELS SHORTED TOGETHER OR TO GROUND - DIAGNOSTIC PROCEDURE
| TEST | ACTION |
|---|---|
| 1 |
NOTE:
The fault condition must be present to continue diagnosis. Use the DRB III to perform the Amplifier Pre-test to verify the fault condition is present before continuing diagnosis.
NOTE:
Inspect the Amplifier harness connector and terminals for damage that could cause several terminals/circuits to contact each other. Repair as necessary. Turn the ignition off.Disconnect the Amplifier C1 harness connector.Measure the resistance between ground and each of the Speaker (+) and (-) circuits (8 circuits total).Is the resistance below 1000 ohms for any of the measurements?
|
| 2 | Turn the ignition off. Disconnect the Amplifier C1 harness connector. Disconnect each speaker harness connector (6 total). Measure the resistance between each Speaker (+) and (-) circuits and every other Speaker circuit. Is the resistance below 1000 ohms for any of the measurements?
|