Test 10A - Vehicle Communications
- Remove and inspect fuse No. 17. If fuse is open, go to TEST 10B - VEHICLE COMMUNICATIONS . If not, go to next step.
- Using voltmeter, measure ignition switch output RUN/START at fuse No. 17. If voltage above 10 volts, go to next step. If voltage not above 10 volts, repair open ignition switch output circuit to fuse No. 17.
- Disconnect battery and wait 2 minutes. Disconnect air bag control module 13-way connector. Reinstall fuse No. 17 and reconnect battery. Use voltmeter to measure fused ignition switch output RUN/START (CAV 1). If voltage is above 10 volts, go to next step. If not, repair open ignition switch output circuit to fuse No. 17.
- Turn ignition off. Using ohmmeter measure ground circuit. If resistance is not above 5 ohms, repair open ground circuit. If resistance is above 5 ohms, jumper CCD BUS (+) circuit to ground. Use DRB to perform BUS TEST. If DRB shows SHORT TO GROUND, go to next step. If not, repair open CCD BUS (+) circuit.
- jumper CCD BUS (-) circuit to ground. Use DRB to perform BUS TEST. If DRB shows SHORT TO GROUND, replace ACM. If DRB does not show SHORT TO GROUND, repair open CCD BUS (-) circuit.