Clock (Service Information): Installation
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Position the clock (1) to the back of the instrument panel center bezel.
- Install and tighten the fasteners (3) that secure the clock to the center bezel.
- Install the center bezel onto the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
- Connect the negative cable to the battery. If equipped with an Intelligent Battery Sensor (IBS), reconnect the IBS connector.
- Depress the clock reset button (4) as necessary to adjust the clock to the proper time setting.