Lower

REMOVAL

1. Position the column tilt at the full-upward position.

2. Remove the steering column opening cover Steering Column Opening Cover - Removal.





3. Remove the steering column cover reinforcement mounting screws (2). Remove the steering column cover reinforcement (1).





4. Position the column tilt at the full-downward position. Leave the tilt lever (2) in the released position.

5. Remove the screws (1) attaching the lower shroud. After removing the screws, un-clip the shrouds from one another by applying hand pressure along the seams where the shrouds connect on the sides.

6. Remove the lower shroud.