Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

OTHER DTCS
1. Turn the ignition on.
2. With the scan tool, read and record the freeze frame data.
3. With the scan tool, read the Engine DTCs.
  Are there any DTCs set for Turbocharger system, BARO Sensor, or Inlet Air Pressure Sensor?
  
  Yes
  - Repair other DTCs before proceeding.
  No
  - Go To 2.
CHECK THE INLET AIR PRESSURE SENSOR
1. Turn the ignition off.
2. Connect a mechanical intake manifold pressure gauge to the engine, as close to the Inlet Air Pressure Sensor as possible.
3. Start the engine.
4. With the scan tool, monitor the Inlet Air Pressure Sensor reading.
  Is the scan tool reading within 2.5 psi of the mechanical intake manifold pressure gauge?
  
  Yes
  - Go To 3.
  No
  - Replace the Inlet Air Pressure/Temperature Sensor in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
CHECK THE INTAKE SYSTEM FOR LEAKS
1. Perform the INTAKE AIR SYSTEM PRESSURE TEST diagnostic procedure. Refer to Diagnosis and Testing , 6.7L .
  Were any Intake System leaks found?
  
  Yes
  - Perform the appropriate repair.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
  No
  - Go To 4.
CHECK THE CHARGE AIR COOLER
1. Remove and clean the Charge Air Cooler with approved Mopar R EGR system cleaner.
2. Reinstall the Charge Air Cooler.
3. With the scan tool, erase DTCs.
4. Turn the ignition off for 75 seconds.
5. Start the engine.
6. Test drive the vehicle. With the scan tool in Data Display, verify that the engine operating mode is normal.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Charge Air Cooler in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .
  No
  - Repair complete.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to POWERTRAIN VERIFICATION TEST - 6.7L .