Diagnostic Test

WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

POWERTRAIN CONTROL MODULE
1. Turn the ignition off.
2. Verify all chassis grounds are properly connected. Perform the CHECKING ECM POWERS AND GROUNDS diagnostic procedure. Refer to Diagnosis and Testing , 6.7L .
3. Turn ignition on, engine not running.
4. With the scan tool, read DTCs.
  Is P0606 stored?
  
  Yes
  - Repair complete.
  No
  - Replace and program the Powertrain Control Module in accordance with the service information. Refer to MODULE, Powertrain Control, 6.7L Diesel, Removal , and PCM/ECM / TCM PROGRAMMING .