LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 436 (6.7L Diesel - DTCS P2299 To U3017 - 2500 Hd & 3500 Hd) >> Diagnosis And Testing >> U3017-Control Module Timer/Clock Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. ACTIVE DTC 
    NOTE:

    Low battery voltage as well or an IOD fuse which is missing or not pushed in completely can cause the DTC to set. Make sure that the battery is fully charged and Ignition Off Draw (IOD) fuse is properly installed before continuing.

    1. Ignition on, engine not running.
    2. With a scan tool clear DTCs.
    3. Turn the ignition off for 75 seconds.
    4. Turn the ignition on.
    5. With a scan tool read DTCs.

      Is the DTC active at this time?

      Yes 

      • Replace and program the Powertrain Control Module in accordance with the Service Information.
      • Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .

      No 

scientia non olet · About LEMON Manuals