Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

OTHER DTCS
1. Ignition on, engine not running.
2. With the scan tool, View DTCs.
  Is DTC U010E active?
  
  Yes
  - Perform the diagnostic procedure for U010E before continuing.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
U05A5 ACTIVE
Is DTC U05A5 active?

Yes
- Go To 3
No
- Perform the INTERMITTENT CONDITION - 6.7L diagnostic procedure. Refer to STANDARD PROCEDURE .
CHECK THE POWERTRAIN CONTROL MODULE
Are there invalid or implausible data DTCs present for other components on the J1939 Data Link?

Yes
- Replace the Powertrain Control Module in accordance with the service information. Refer to MODULE, POWERTRAIN CONTROL, 6.7L DIESEL [ETK], REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
No
- Replace the Ammonia Sensor Module in accordance with the service information.
- Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .