Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
NOTE:
If DTCs P2202, P229E, or P2209 are present, perform the diagnostic for those DTCs before continuing with this test procedure.
1. Start the engine, monitor Exhaust Gas Temperature Sensor 4 until it reaches 150°C (302°F).
2. Drive the vehicle at 50 MPH, ensure that it is not in DPF Regeneration mode.
3. Perform a zero fueling event (decel condition for 10 seconds, with foot off of accelerator pedal).
4. Repeat this condition three to five times.
5. With the scan tool check active DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION - 6.7L diagnostic procedure. Refer to STANDARD PROCEDURE .
CHECK FOR EXCESSIVE ENGINE OIL BEING INTRODUCED INTO THE AFTERTREATMENT SYSTEM
1. Turn the ignition off.
2. Remove the turbocharger outlet and inspect for signs of oil, fuel or moisture being introduced into the aftertreatment system from the engine.
  Was engine oil, fuel or moisture found in the turbocharger exhaust outlet?
  
  Yes
  - Locate the cause of possible diesel fuel or engine oil being carried from the engine into the exhaust system. Inspect the SCR Catalyst for possible damage.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Replace the NOx Sensor 1/1 in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .