Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, record all Freeze frame data.
3. With the scan tool, erase DTCs.
4. Turn the ignition off for 75 seconds.
5. Start the engine and let idle for one minute.
6. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
CHECK THE (N32) INTAKE AIR DIVERTER COMMAND CIRCUIT FOR A SHORT TO GROUND
1. Disconnect the PCM C1 harness connector.
2. Disconnect the IAD Valve harness connector.
3. Measure the resistance between ground and the (N32) IAD Command circuit at the IAD Valve harness connector.
  Is the resistance below 10k Ohms?
  
  Yes
  - Repair the (N32) IAD Command circuit for a short to ground.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK THE (N32) INTAKE AIR DIVERTER COMMAND CIRCUIT FOR AN OPEN/HIGH RESISTANCE
1. Measure the resistance of the (N32) IAD Command circuit between the PCM harness connector and the IAD Valve harness connector.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Go To 4
  No
  - Repair the (N32) IAD Command circuit for an open or high resistance.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
CHECK THE (N32) INTAKE AIR DIVERTER COMMAND CIRCUIT FOR A SHORT TO THE (Z915) VALVE GROUND
1. Measure the resistance between the (N32) IAD Command circuit and the (Z915) Valve Ground at the IAD Valve harness connector.
  Is the resistance below 10k Ohms?
  
  Yes
  - Repair the short between the (N32) IAD Command circuit and the (Z915) Valve Ground.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Go To 5
INTAKE AIR DIVERTER VALVE
1. Replace the Intake Air Diverter Valve in accordance with the Service Information.
  NOTE:
  The Intake Air Diverter valve cannot be serviced separately. It is part of the Air Box.
2. Reconnect the IAD Valve harness connector.
3. Reconnect the PCM C1 harness connector.
4. Turn the ignition on.
5. With the scan tool, erase DTCs.
6. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Replace Powertrain Control Module in accordance with the Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .
  No
  - Repair complete.
  - Perform the POWERTRAIN VERIFICATION TEST - 6.7L. Refer to STANDARD PROCEDURE .