LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 419 (5.7L CNG - DTCS P2135 To U147B - 2500 Hd) >> Diagnosis And Testing >> P224E-Alternative Fuel Tank Shutoff Valve Control Circuit Low >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 2500 HD and 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. ACTIVE DTC 
    1. Turn the ignition on.
    2. With the scan tool, navigate to Actuators and actuate the CNG Shutoff Relay to on or toggle.
    3. With the scan tool, view DTCs.

      Is the status active or pending for this DTC?

      Yes 

      • Go To  2

      No 

  2. CHECK THE (F342) FUSED ASD RELAY OUTPUT CIRCUIT VOLTAGE 
    1. Turn the ignition off.
    2. Disconnect the CNG Shutoff Relay harness connector.
    3. Turn the ignition on.
    4. Measure the voltage of the (F342) Fused ASD Relay Output circuit at the CNG Shutoff Relay harness connector.

      Is the voltage approximately equal to battery voltage?

      Yes 

      • Go To  3

      No 

      • Repair the (F342) Fused ASD Relay Output circuit for an open or high resistance. If the fuse is found to be blown, check the circuit for a short to ground.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  3. CHECK THE (K600) CNG SHUTOFF CONTROL CIRCUIT FOR A SHORT TO GROUND 
    1. Turn the ignition off.
    2. Disconnect the PCM C2 harness connector.
    3. Measure the resistance between ground and the (K600) CNG Shutoff Control circuit at the Gasoline Fuel Injector Relay harness connector.

      Is the resistance above 10k Ohms?

      Yes 

      • Go To  4

      No 

      • Repair the (K600) CNG Shutoff Control circuit for a short to ground.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  4. CNG FUEL INJECTOR RELAY 
    1. Turn the ignition off.
    2. Replace the CNG Shutoff Relay in accordance with the service information.
    3. Turn the ignition on.
    4. With the scan tool, erase DTCs.
    5. With the scan tool, navigate to Actuators and actuate the CNG Shutoff Relay to on or toggle.
    6. With the scan tool, select view DTCs.

      Did the DTC return?

      Yes 

      • Replace the Powertrain Control Module in accordance with the service information.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .

      No 

      • Repair complete.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals