Diagnostic Test
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE
- Turn the ignition on.
- With the scan tool, read the active DTCs.
Does the scan tool display U0037-11-LIN BUS - CIRCUIT SHORT TO GROUND?
Yes
- Go To 2.
No
- Perform the STORED LOST COMMUNICATION DTCS for 1500, 2500 and 3500, or STORED LOST COMMUNICATION DTCS for 3500 Cab & Chassis, 4500 and 5500 diagnostic procedure .
- CHECK THE LIN BUS CIRCUIT
- Turn the ignition off.
- Disconnect the Driver Window/Door Lock Switch C1 harness connector.
- Turn the ignition on.
- Measure the voltage between the (D500) LIN Bus circuit and the (D501) LIN Bus Return circuit.
Is the voltage below 7.0 Volts?
Yes
- Go To 3.
No
- Replace the Driver Window/Door Lock Switch.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
- (D500) LIN BUS CIRCUIT SHORTED TO GROUND
- Turn the ignition off.
- Disconnect the Driver Door Module C5 harness connector.
- Measure the resistance between ground and the (D500) LIN Bus circuit in the Door Module C5 harness connector.
Is the resistance below 10,000 Ohms?
Yes
- Repair the short to ground in the (D500) LIN Bus circuit.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
No
- Go To 4.
- (D500) LIN BUS CIRCUIT SHORTED TO THE (D501) LIN BUS RETURN CIRCUIT
- Measure the resistance between the (D500) LIN Bus circuit and the (D501) LIN Bus Return circuit in the Door Module C5 harness connector.
Is the resistance below 10,000 Ohms?
Yes
- Repair the (D500) LIN Bus circuit for a short to the (D501) LIN Bus Return circuit.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
No
- Replace the Driver Door Module in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST for 1500, 2500 & 3500, or BODY VERIFICATION TEST for 3500 CAB & CHASSIS, 4500 & 5500 .
- Measure the resistance between the (D500) LIN Bus circuit and the (D501) LIN Bus Return circuit in the Door Module C5 harness connector.