Diagnostic Test

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE
1. Perform any Service Bulletins that may apply.
2. Turn the ignition on.
3. With the scan tool, read and record the Environmental Data to help identify the conditions in which the DTC was set.
4. With the scan tool, record and erase DTCs.
5. With the scan tool, read ASCM DTCs.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Go To 3
AIR SUSPENSION CONTROL MODULE (ASCM)
1. Start the vehicle.
2. With the scan tool, erase DTCs.
3. Place the vehicle in "Transport Mode" switch to ON.
4. Wait 45 seconds.
5. With the vehicle in "Transport Mode" switch to OFF.
6. Wait 45 seconds.
7. With the scan tool, read ASCM DTCs.
  Does the DTC remain active?
  
  Yes
  - Replace the Air Suspension Control Module (ASCM) in accordance with the Service Information. Refer to MODULE, AIR SUSPENSION CONTROL (ASCM), REMOVAL .
  - Perform the ASCM VERIFICATION TEST. Refer to STANDARD PROCEDURE - ASCM VERIFICATION TEST .
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension and repair as necessary. If no problems are found, test complete.
INTERMITTENT WIRING, CONNECTORS AND AIR LINES
1. Inspect the intake and exhaust air lines for leaks, restrictions, debris, or contamination.
2. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
3. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
4. Look for the data to change or for the DTC to reset during the wiggle test.
5. While monitoring the scan tool data relative to this circuit, move the selector switch to each position several times.
6. Look for the data to change other than as expected or for the DTC to reset.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ASCM VERIFICATION TEST. Refer to STANDARD PROCEDURE - ASCM VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time.