LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1633 (Wiper System & Washer System - (Service Information) - 2500 Hd) >> Module, Light Rain Sensor >> Removal

Module, Light Rain Sensor: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154621Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery.
  2. Remove the trim cover from the inside rear view mirror mounting bracket (3). Refer to MIRROR, REARVIEW, REMOVAL .
  3. Disconnect the wire harness connector (4) from the Light Rain Sensor Module (LRSM) (5).
  4. Depress one side of the spring steel retaining strap on the LRSM towards the windshield (1) while lightly prying the end of the strap closest to the glass away from the tab of the mounting bracket (2) on the windshield. Now rotate the loose side of the LRSM away from the glass far enough to disengage the other side of the strap from the other mounting bracket tab.
  5. Remove the LRSM from the vehicle.
scientia non olet · About LEMON Manuals