LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1626 (Passive Entry Module (PEM) - (Service Information) - 2500 Hd) >> Antenna, Passive Entry >> Removal >> Center Floor Console

Center Floor Console

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0158194Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Perform the center floor console removal procedure. The floor console does need to be completely removed from its installation points and at least pushed back far enough to access the Occupant Restraint Controller (ORC) and LF antenna. Refer to CONSOLE, FLOOR, LID, REMOVAL .
  3. The LF antenna (2) is attached to the ORC bracket (4). The controller (5), cover, and bracket all need to be removed to gain access to the mounting screws of the LF antenna. Refer to MODULE, OCCUPANT RESTRAINT (ORC), REMOVAL .
    GC0158134Courtesy of CHRYSLER GROUP, LLC
  4. With the ORC module bracket removed, you can now access the two screws (1) that secure the LF antenna to that bracket.
  5. Remove the LF antenna.
scientia non olet · About LEMON Manuals