Section 1619 (Rear Axle - 292 Aa (11 1/2) - 2500 Hd): Specifications
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
AXLE SPECIFICATIONS
| DESCRIPTION | SPECIFICATION |
|---|---|
| Axle Ratio | 3.42, 3.73, 4.10 |
| Ring Gear Diameter | 292 mm (11.5 in.) |
| Ring Gear Backlash | 0.18 - 0.28 mm (0.007 - 0.011 in.) |
| Pinion Torque To Rotate - New Bearings | 2.25 - 2.82 N.m (20 - 25 in. lbs.) |
| Pinion Torque To Rotate - Original Bearings | 1 - 2 N.m (9 - 18 in. lbs.) |
| Fill Level - From Bottom of Fill Hole | 6 mm (1/4 in.) ± 6 mm (1/4 in.) |
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | COMMENT |
|---|---|---|---|---|
| Adjuster Lock Bolt | 25 | 18 | - | - |
| Axle Flange Bolts | 41 + 37° | 30 + 37° | - | - |
| Bearing Cap Bolts | 282 | 208 | - | - |
| Brake Backing Plate To Flange Nut | 190 | 140 | - | - |
| Differential Cover Bolts | 39 | 29 | - | - |
| Fill Hole Plug | 32 | 24 | - | - |
| Hub Bearing Nut | Refer to BEARING, AXLE SHAFT, INSTALLATION . | - | ||
| Ring Gear Bolts | 80 + 68° | 59 + 68° | - | Do not reuse these fasteners. If removed, a NEW fastener must be installed and tightened to specifications. |