Section 1598 (Instrument Cluster - (Service Information) - 2500 Hd): Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Position the instrument cluster close enough to the instrument panel to connect the instrument panel wire harness connector (1) to the connector receptacles on the back of the cluster (1) housing.

Courtesy of CHRYSLER GROUP, LLC
Position the instrument cluster (1) into the instrument panel (2).
Install and tighten the two screws (3) that secure the instrument cluster to the instrument panel. Tighten the screws to 4 N.m (31 in. lbs.).
Install the cluster bezel onto the instrument panel. Refer to BEZEL, INSTRUMENT CLUSTER, INSTALLATION .
Connect the negative battery cable.

NOTE:

Certain indicators in this instrument cluster are automatically configured. This feature allows those indicators to be activated or deactivated for compatibility with certain optional equipment. If a problem is noted that involves improper illumination of the cruise indicator, the electronic throttle control indicator, the fog lamp indicator, any of the four-wheel drive indicators, the overdrive OFF indicator, the tow/haul indicator, the transmission over temp indicator, the security indicator or the gear selector indicator, disconnect and isolate the battery negative cable. After about five minutes, reconnect the battery negative cable and turn the ignition switch to the ON position. The instrument cluster should automatically relearn the equipment in the vehicle and properly configure the configurable indicators accordingly.