LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Keyless Ignition Node (Kin) >> Installation

Module, Keyless Ignition Node (Kin): Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the ignition to the vehicle for installation.
  2. Secure the ignition switch to the vehicle using four screws.
  3. Connect the wiring harness connector to the back of the ignition.
  4. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  5. Connect the negative battery cable.
  6. Perform the Radio Frequency Hub (RF Hub) Module verification test. Refer to RADIO FREQUENCY HUB (RF HUB) VERIFICATION TEST .
  7. Program the Fobiks. .
scientia non olet · About LEMON Manuals