Gas - Left Side

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Remove the battery from the battery tray. Refer to BATTERY, REMOVAL .
If equipped and mounted to the battery tray, remove the Hydraulic Control Unit (HCU). Refer to HYDRAULIC CONTROL UNIT (HCU), REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Open the Power Distribution cover (PDC) and remove the B+ cable bolt (1).

Courtesy of CHRYSLER GROUP, LLC
Unclip all wiring harness wire hold downs (1) on the battery tray. There are 6 hold downs.

Courtesy of CHRYSLER GROUP, LLC
Remove the clips (1) at the PDC base.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness retainers (1) from the battery tray assembly including those in the PDC portion of the tray.

Courtesy of CHRYSLER GROUP, LLC
Partially remove the radiator cover by removing two clips (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the three bolts (2) and remove the support bracket (1) behind the headlight.

Courtesy of CHRYSLER GROUP, LLC
Remove four bolts (1) securing the battery tray to the fender wall.
Remove the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE .

Courtesy of CHRYSLER GROUP, LLC
Remove the two lower battery tray bolts (1).

Courtesy of CHRYSLER GROUP, LLC
When removing the battery tray for replacement, transfer the battery tray spacer (1) (if equipped) to the new battery tray.