LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1602 (Antilock Brake System (Abs) - (Service Information) - 2500 Hd) >> Hydraulic/Mechanical >> Hydraulic Control Unit (HCU) >> Removal

Hydraulic Control Unit (HCU): Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery cables from the battery.
  2. Using a brake pedal holder, depress the brake pedal past its first one inch of travel and hold it in this position. This will isolate the master cylinder from the brake hydraulic system and will not allow the brake fluid to drain out of the master cylinder reservoir.
    GC0155434Courtesy of CHRYSLER GROUP, LLC
  3. Remove the brake lines (1) from the master cylinder.
  4. Remove the left front wheel house splash shield. Refer to REMOVAL .
    GC0155417Courtesy of CHRYSLER GROUP, LLC
  5. Remove the retainers (2) and remove the shield (1).
    GC0155446Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the electrical harness connector (5).
  7. Remove the brake lines from the HCU (1).
  8. Remove HCU/ABM outer mounting bolts (2) from the HCU/ABM.
    GC0155478Courtesy of CHRYSLER GROUP, LLC
  9. Remove the inner mounting bolt (2) and remove the HCU/ABM.
scientia non olet · About LEMON Manuals