LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1582 (Heating & Air Conditioning - (Service Information) - 2500 Hd) >> Plumbing >> Line, A/C Discharge >> Removal >> 6.7L Diesel Engine

6.7L Diesel Engine

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

GC0137177Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air filter housing.
  4. Disconnect the wire harness connector from the A/C pressure transducer (1).
  5. Remove the nut (3) that secures the A/C discharge line (2) to the condenser jumper line tapping block (4).
  6. Disconnect the A/C discharge line from the condenser jumper line tapping block and remove and discard the O-ring seal and gasket.
    GC0137128Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Illustration shown with lower radiator hose removed for clarity.

  7. Remove the turbocharger outlet tube.
  8. Remove the nut (1) that secures the A/C discharge line (4) to the A/C compressor (2).
  9. Disconnect the A/C discharge line from the A/C compressor and remove and discard the O-ring seal and gasket.
  10. Install plugs in, or tape over the opened discharge line fittings and the compressor and jumper line ports.
  11. If necessary, remove the A/C pressure transducer from the A/C discharge line. Refer to TRANSDUCER, A/C PRESSURE, REMOVAL .
scientia non olet · About LEMON Manuals