Transducer, A/C Pressure: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
NOTE:
Typical A/C pressure transducer and refrigerant line shown.
- Disconnect and isolate the negative battery cable.
- Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the A/C discharge line (3).
- Remove the A/C pressure transducer from the fitting on the A/C discharge line and remove and discard the O-ring seal.