LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1582 (Heating & Air Conditioning - (Service Information) - 2500 Hd) >> Controls >> Control, A/C And Heater >> Installation

Control, A/C And Heater: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0083759Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical A/C-heater control shown.

  1. Position the A/C-heater control (2) onto the back of the instrument panel center bezel (1).
  2. Install the four screws (3) that secure the A/C-heater control to the center bezel. Tighten the screws to 2.2 N.m (20 in. lbs.).
  3. Connect the wire harness connectors (4 and 5) to the back of the A/C-heater control and install the instrument panel center bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, INSTALLATION .
  4. Reconnect the negative battery cable.
  5. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals