LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (6.4L Engine - (Service Information) - 2500 Hd) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0081773Courtesy of CHRYSLER GROUP, LLC
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

NOTE:

This procedure can be performed in vehicle.

  1. Disconnect the negative battery cable.
  2. Remove the transmission (Refer to 66RFE Transmission REMOVAL and BW44-46 Transfer Case REMOVAL or BW44-47 Transfer Case REMOVAL ).
  3. Remove the flexplate. Refer to FLEXPLATE, REMOVAL  .
  4. Remove the oil pan. Refer to PAN, OIL, REMOVAL  .
  5. Using the sequence shown, remove the rear oil seal retainer mounting bolts.
  6. Carefully remove the retainer from the engine block.
scientia non olet · About LEMON Manuals