LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Engine Mounting >> Insulator, Engine Mount, Front >> Removal >> Right Side

Right Side

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0161582Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both of the both negative battery cables.
  2. Remove the engine oil dipstick (2).
  3. Remove the bolts (1) and the engine cover (3).
  4. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL, 6.7L .
  5. Remove the right front tire and wheel assembly.
  6. Remove the right front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE .
  7. If equipped, remove the left side generator and mounting bracket. Refer to GENERATOR, REMOVAL .
    GC0168121Courtesy of CHRYSLER GROUP, LLC
  8. Install the (special tool #10474, Brackets, Engine Lifting) (1) and securely tighten bolts (2).
  9. Install Engine Support Fixture tool (special tool #8534C, Fixture, Driveline Support).
  10. Raise and support the vehicle.
    GC0137135Courtesy of CHRYSLER GROUP, LLC
  11. Loosen both of the engine mount thru-bolt and nuts (1).
  12. Remove support and lower the vehicle.
  13. Lift the engine SLIGHTLY  and remove the left side thru-bolt and nut (1).
  14. Partially raise and support the vehicle.
  15. Remove the bolts securing the transmission cooler lines to the frame.
  16. Detach the NOx sensor and turbocharger speed sensor wire harness retainer.
    GC0137136Courtesy of CHRYSLER GROUP, LLC
  17. Going through the wheel well, remove the bolts (1) and the right engine mount (2).
scientia non olet · About LEMON Manuals