LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Front Suspension & Wheel Alignment - 2500 Hd) >> Front, Link And Coil >> Knuckle, Steering >> Installation

Knuckle, Steering: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the steering knuckle on the ball studs.
  2. Install and tighten lower ball stud nut to initial torque  specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  3. Install and tighten upper ball stud nut to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  4. Re-torque lower ball stud nut to final torque  specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  5. Install the hub bearing. Refer to HUB AND BEARING, INSTALLATION .
  6. Install tie-rod or drag link end onto the steering knuckle arm and tighten to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  7. Install the wheel speed sensor. Refer to SENSOR, WHEEL SPEED, FRONT, INSTALLATION .
scientia non olet · About LEMON Manuals