LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Front Suspension & Wheel Alignment - 2500 Hd) >> Front, Link And Coil >> Hub And Bearing >> Installation

Hub And Bearing: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0107542Courtesy of CHRYSLER GROUP, LLC
  1. Position the brake shield (1) on bolts.
  2. Install the hub/bearing to the knuckle and tighten the hub/bearing bolts (2) to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
    GC0155475Courtesy of CHRYSLER GROUP, LLC
  3. Install the hub nut (1) and tighten to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  4. Install the wheel speed sensor to the hub. Refer to SENSOR, WHEEL SPEED, FRONT, INSTALLATION .
  5. Install the disc brake rotor. Refer to ROTOR, BRAKE, INSTALLATION .
  6. Install the brake caliper adapter with the caliper. Refer to ADAPTER, DISC BRAKE CALIPER, INSTALLATION .
  7. If equipped, install the hub extension and nuts to the front rotor and tighten nuts to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  8. Install the wheel and tire assemblies. Refer to WHEELS, STANDARD PROCEDURE .
  9. Remove the support and lower the vehicle.
  10. Apply the brakes several times to seat the brake shoes and caliper piston. Do not move the vehicle until a firm brake pedal is obtained.
scientia non olet · About LEMON Manuals