Ball Joint, Suspension, Upper: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Position Remover/ Installer (special tool #8445-2, Installer, Cup) (DRIVER) (2) and Ball Joint Remover/Installer (special tool #8975-5, Receiver, Ball Joint) (RECEIVER) (5) with Ball Joint Press (special tool #C-4212F, Press, Ball Joint) (1) as shown to install upper ball stud (3).
- Install the axle shaft into the axle. Go to INSTALLATION .
- Install the steering knuckle. Refer to KNUCKLE, STEERING, INSTALLATION .