Ball Joint, Suspension, Lower: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Position Ball Joint Remover/Installer (special tool #10509, Installer, Ball Joint) (2) and Ball Joint Remover/Installer (special tool #8975-3, Cup, Remover) (5) with Ball Joint Press (special tool #C-4212F, Press, Ball Joint) (1) as shown to install lower ball stud (3).
- Install the axle shaft into the axle. Go to INSTALLATION .
- Install the steering knuckle. Refer to KNUCKLE, STEERING, INSTALLATION .