Power With Vented Seat
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front seat. Refer to SEAT, FRONT CENTER, REMOVAL .
- Separate the seat back cover straps (2) from under the seat cushion and disconnect the electrical connectors (1).
- Remove the side shield screws (2) in the back.
- Remove the inboard shield screw.
- Remove the inboard side shield.CAUTION:
Disconnect the lumbar control switch electrical connector beneath the seat, prior to removing the power seat switch bezel from the seat. Failure to follow these instructions can result in damage to the lumbar control switch.
- If equipped, disconnect the lumbar control switch electrical connector (1).NOTE:
Power seat bezel shown in the illustration, manual seat bezel similar.
- Using trim stick (special tool #C-4755, Trim Stick) or equivalent, release the seven tabs (3) and separate the bezel (1) from the outboard side shield.
- Pull the bezel (1) rearward and release the front retaining tab (2).
- Disconnect the wire harness connectors from the power seat switch and memory seat switch, if equipped.
- Remove the screw (1).
- Release the retaining clips (2) and remove the outer side shield.
- Disconnect the vented seat bag (1) from the motor (2).
- Disconnect the electrical connectors, if equipped.
- Separate the cover J-straps (1) from the sides and remove the foam/cover assembly.
- Remove the 10 hog rings (2) and separate the cover (1) from the foam.
- Pull the vent pad (1) through the foam.